Cisco Default Login – IP Address, Username and Password
Default Logins for Cisco
Cisco Router Login
Having difficulty with your router’s wi-fi network? Want to secure network by changing network credentials? Or you want some other changes in your Cisco router’s Configuration?
All of this can be done after getting logged in to your Cisco router setup pages. After logging in to the browser-based setup pages, Cisco allows us to change their configuration.
What you’ll need
Normally everyone has these things already in their places.
– A computer or laptop with an internet browser.
– Your Cisco router
– An ethernet cable or Wi-Fi connection.
Cisco Login Steps
We’re giving you the most user-friendly way to manage your Wi-Fi network and router. As many users don’t want to mess around with complicated command-line instructions.
There is a standard procedure to access these setup pages. Almost every Cisco router follows the same procedure.
Make Sure You are Connected with Cisco Router Network
First, get a connection with your router in order to get access to web-based setup pages. Make sure that your router is on. You can use an ethernet or Wi-Fi connection. But we recommend using an ethernet connection because there is no need for any username or password while using ethernet.
To do this, plug an ethernet cable into a port on your router and one of the ports on your laptop. For connection using Wi-Fi, look at the list of available networks on your computer and connect to it. If you’re able to successfully done, then we can proceed to the next step.
Open web browser you are using and in the address bar type 192.168.1.1. This is the default gateway and will give you access to the Cisco router login page.
192.168.1.1 is the most commonly used IP address for Cisco routers. In any case, if it doesn’t work, there is a list of other possible IP addresses. Also, try using;
http://192.168.1.1
10.0.0.1
Find Your Router IP Address Using ‘ipconfig’
Find your IP address by running an IP config scan through the following steps;
#1: Press Window + R and type cmd and hit enter.
#2: Type ‘ipconfig’ and hit enter.
#3: Find the Cisco router’s IP address next to the default gateway.
Use Default Username & Password to Log In.
The default login credentials of Cisco routers are used for easy to access the setup pages. The most common combination is:
User: admin
Password: admin
OR
User: Cisco
Password: Cisco
You can also find your router default credentials from the back or side of your router. If you forgot your router credentials after changing them, then you will need to reset your router to its default configuration.
Configure the Cisco Router & Change Settings
You should now get access to the router’s setup pages. From here you can change your router’s security settings, change your login details, or reset your router.
Before changing any settings write down it so that you can retrace your steps if something goes wrong. If you change your router credentials, write these down too that you don’t forget.
Troubleshooting
You might mistakenly configure some settings you’re not supposed, after which your router does not work properly. But don’t worry! you can always set your router to its default factory settings.
How to Reset Your Router to its default Settings
#1: Find the reset button at the back or side of your router. Its usually a very small button and you may need a pin or something very thin to press it.
#2: Press and hold the reset button for 15 seconds. If you do not press it for enough time the router will restart and not will reset.
#3: The router will start booting give it 5 to 10 minutes to finish booting. When lights stop blinking then it means it is done.
#4: Switch off the router. It’s now reset to its default factory settings. Next time it will need the default credentials.
If you are at your bad luck and no step works then pick up the phone and give Cisco a call. May be its because you have a non-standard configuration router. So, collect all information at the back of the router and by finding the user manual or packaging.